Frequent problems and solutions in spray drying equipment

Spray drying equipment is mostly a chemical industry, and the food industry is used to make solutions and suspensions into a kind of drying equipment. The use of materials and hot gas through full contact with the coexistence and other means, so that fast drying, is a powerful tool to obtain powdered products. Spray drying equipment has good drying effect and little dust pollution, so it is very popular in the industry. However, there are some problems in the spray drying equipment that will affect the drying effect of the whole material. So Xiao Bian analyzes briefly here, the problems and solutions that often occur during the use of spray drying equipment.
1. The spray drying equipment does not atomize. This situation is generally a clogged nozzle or there is wear. The nozzles of the replacement device should be cleaned frequently.
2. Into the air and exhaust air temperature is not appropriate, too high or too low. This situation is a stress issue. In the process of use, it is necessary to properly adjust the air intake and exhaust pressure of the machine.
3. The finished product after drying has high moisture content and poor drying effect. There are many possibilities for such a situation, materials, drying temperature, air intake, heating area, etc. may affect, so we should first find the reasons for the adjustment.
4. Dry finished product has impurities or color difference. Generally it is not cleaned in the air, it may be because the temperature during hot processing is too high or too low, and the whole material is in a form, resulting in color difference.

Door Frame Cover

Adhesive door frame edges need to be selected according to the material, generally you can use instant glue, slow-dry glue, nail-free glue, UV shadowless glue, swelling glue, etc.

When repairing viscose, to avoid applying glue on a large area, you only need to divide the door frame into four equal parts, and point five points. The two ends and the middle must be glued, and then installed Go back and hold it for a few minutes, and after letting go, the door frame edge will not fall off.

Different glues have different effects, and you should choose and use them according to the material and specific conditions of the door frame edge.

The most convenient way is to use instant glue. After the glue is applied, it can stick together immediately, and the effect is relatively good. The effect is very good for metal and plastic parts. But this kind of glue is easier to paint, and it is easy to have white edges around it after a long time.

The filling effect of slow-drying glue is good, and it will not cause white fog, and at the same time, it will not appear embrittlement. The longer it is used, the better the adhesion will be, but the drying will be slower.

In the case of sticking wooden doors, you can use nail-free glue. Before using, clean the surface to ensure that the surface is free of oil and dust, and then use a sealing gun to squeeze out the glue.

UV shadowless glue belongs to two kinds of bonding. It is only effective if it is a transparent part. The bonding strength is also relatively good, and it dries quickly. After this glue is irradiated by ultraviolet rays, the reaction will be strong and the efficiency is very high. .

Wood Glue Door Frame

Door Frame Cover,High Strength Hot Glue,Hot Melt Pellets,Industrial Hot Glue

GUANGZHOU INTERNET WOOD GLUE MANUFACTURER CO. LTD. , https://www.hotmeltadhesiveiwg.com