The problems solved According to the progress of each unit project and the feedback, Weihai Conference reported three aspects: 1 project basis, main research content, expected goals, patent results, research methods, application prospects and schedules, etc. And summarize the current status of wind turbine products at home and abroad, and introduce the modern design methods that will be adopted in this project. 2 The structure improvement plan of the ventilator, the test drive set solution, etc. It is recommended that most of the fans of this project adopt a tapered front plate and a straight inlet vent, which will bring a series of advantages such as cost and efficiency. 3 The progress of the test bed construction of this project and pointed out the reasons for the unified test platform. The test bench will use the inlet air chamber test, and the multi-nozzle in the air chamber will measure the flow rate. The standard adopted is GB/T1236-2000. At present, the design work of this test bench has been fully completed, and some test equipments have been purchased and developed. For example, torque sensor, ventilator test data automatic system, etc. Representatives and experts from various companies participating in the project expressed their opinions on the problems in the project implementation process and put forward their own views and solutions on some specific issues. As for the measurement method of the power in the test, the torque meter and the balance motor are used at the same time, the gap between the impeller and the air inlet is unified, and the test is to agree on the influence of different opening degrees of the door on the performance of the fan. The Weihai Conference can see that the importance of high-efficiency energy-saving centrifugal fan series to upgrade the industry products is undoubtedly the joint research of the wind turbine industry joint research institutes and key enterprises in the environment of national promotion and independent innovation. An important measure for the industry to enhance its competitiveness in the future. While hoping to get support from the whole industry, I also hope that the general machinery industry will not only rely on its own strength, but also fully mobilize all aspects of social resources, and dig out more good projects for enterprises, develop new products for the industry, and enhance the ability to innovate. We look forward to The results of this research will be realized as soon as possible, and it is hoped that this achievement will bring benefits to the industry at an early date. PVC Edge Banding For Furniture
The main function of the edge banding is to seal the cross-section of the board, so as to avoid the damage of the board and the adverse factors (mainly moisture) in the process of use and prevent the formaldehyde inside the board from volatilizing, and at the same time achieve the effect of beautiful decoration.
The product has the following main features: smooth surface, no blistering, no ribbing, moderate gloss, smooth surface and back surface, uniform thickness, uniform width, reasonable hardness, high elasticity, good quality, strong wear resistance, trimmed and sealed The color of the side and the side is close to the surface color, not whitish, good gloss, and the overall color of the finished furniture is coordinated.
Furniture edge banding is a material for protecting, decorating and beautifying the section of furniture panels. It can make a piece of furniture show the overall effect of clear wood grain and colorful.
PVC furniture edge banding is relatively light, which is relative to metal and plexiglass. The reason for the lightness is not because it is a polymer compound, but because they are organic compounds, which are composed of carbon, hydrogen, oxygen, and chlorine. And other lighter elements. PVC Edge Banding For Furniture,Pvc Edge Banding For Furniture, Edge Banding For Furniture,Pvc Edge Banding Tape Henan Shunbang Chemical Industry CO.,Ltd , https://www.spvcresin.com
The material of pvc furniture edge banding is plastic, which is easy to process. Plastic has plasticity, that is, it deforms after heating or pressurizing, and maintains its original shape after the temperature drops or the pressure disappears. It can be processed into edge bands of their respective shapes by extrusion and other methods, such as T-shaped edge bands, H-shaped edge bands, D-shaped edge bands, V-shaped edge bands, I-shapes, and so on.
pvc furniture edge banding is of high quality and low price, and the price of plastic is far less than that of metal.