Winter operation skills of wrecker

The rain and snow weather is full of whiteness everywhere, which will burden the driver's eyes. At this time, you must not drive the vehicle for a long time, and it is best to take a rest at an interval of two hours. Wrecker trucks have heavy rescue tasks in rain and snow. The tools needed to clean up faulty vehicles and snow chains used in snow must be prepared in advance to avoid the lack of tools in the busyness and the emergency rescue. At the same time, rain and snow will increase the difficulty of rescue, so wrecker drivers must be proficient in the use of wreckers, which will affect the common safety of themselves and the rescued vehicle!

Wrecker manufacturer phone

According to the actual situation of the parking location of the faulty vehicle, choose to drive the wrecker to a suitable location for the vehicle being carried. The specific steps are as follows:

1. Disengage the winch clutch first, pull out the steel cable to the front of the vehicle being carried, and hook the hook "j" to the traction shackle at the lower part of the towed end of the vehicle being carried. Then engage the clutch of the winch. Note that the number of wire rope turns left when pulling out the wire rope shall not be less than 5 turns.

2. The transported vehicle must be in neutral gear and the parking brake of the transported vehicle must be released.

3. Control the winch lever to pull the car onto the platform, and control the j-shaped hook on the steel cable to be more than 0.4m away from the winch. When the winch is under load, do not disengage the manual control clutch of the winch, as this will damage the winch. Note: When using the chain hook and the winch to tow the accident car, for the car with the lower chassis, be very careful not to damage the towed part, so as not to cause unnecessary trouble.

Wrecker manufacturer phone

4. When the loaded vehicle has been towed in place, tie the rear tire with a safety strap, and fasten the loaded vehicle diagonally to both sides of the flat pull ring. Note: If the safety tab is broken, the safety strap should be wrapped around a solid part of the car. If you cannot manually lock the safety bandage, you can control the winch lever to operate the winch to move the loading vehicle forward a bit, so that the safety chain is properly tensioned.

5. Flatbed wrecker, when using straps to fix the faulty car on the flatbed, all four straps must be locked to the wheels or body.

6. The strap ratchet must be in the closed state when locked.

Note: The nylon bandage will become loose if it is tightened for a long time. You should check the bandage tightness regularly during operation, especially in the case of bad road conditions or sudden braking, you should check the tightening in time to avoid accidents.

Wrecker manufacturer phone

7. Control the platform to tilt the joystick to raise the tail of the platform 0.15m from the ground.

8. Control the platform to tilt the joystick to move the platform forward about 0.6m away from the front end of the cab, and control the platform to tilt the joystick to return the platform to a horizontal position.

9. The sliding joystick of the control platform is to move the platform forward to the front end of the cab.

Wrecker manufacturer phone

10. In order to prevent the possible damage to the winch due to vibration and the pulling force of the steel cable during the following driving, two other safety chains must be used to fix the front end of the car in accordance with the aforementioned method and tighten it as much as possible. Load positioning and tightening.

11. Put the loaded car into first gear and put on the handbrake.

12. Check whether all safety chains or chain belts and connections are firm and tight.

13. After the above steps are completed, follow-up work procedures will be carried out immediately. Step on the clutch of the road wrecker, disengage the power take-off, and the platform loading operation is completed.

Wrecker manufacturer phone

In winter, there is a lot of rain and snow, and the road conditions are poor in rain and snow. The line of sight conditions are not good, which will increase the difficulty of clearing obstacles. Drivers of wrecker trucks must be proficient in wrecking and rescue skills, which is related to the common safety of themselves and the rescued vehicle!

Wrecker manufacturer phone

Double Cone Mixer

Double Cone Powder Mixer,Double Cone Blender,Double Cone Blender Mixer,Double Cone Mixer

Jiangsu Hongda Powder Equipment Co., Ltd , https://www.hdpowderexpert.com