4x4 Four Wheel Drive Backhoe Loader Shandong Davoo Machinery Co., Ltd. Trading Company , https://www.nbsddigger.com
Maintenance of CNC slides when they are not used for a long period of time Due to certain reasons, when CNC punches are not used for a long time, in order to avoid failures when CNC punch presses are put into use, the following points must be noted:
1. For the long-term deactivated slides, slides and other moving parts of the NC slide, grease should be applied before use to prevent rust or corrosion on the moving parts;
2. If the feed shaft or spindle of the CNC punch press adopts a DC motor, the brush shall be taken out of the DC motor so as to prevent corrosion of the surface of the commutator due to chemical corrosion, resulting in a decrease in the performance of the commutator, or even causing the entire commutator to deteriorate. Taiwan motor damaged.
3. Always power the NC sliding table. This should be the case in the rainy season when the humidity is relatively high. When the machine tool is locked (ie, the servo motor does not rotate), the numerical control system is allowed to run empty. The heat of the electrical component itself is used to dissipate the moisture in the system and ensure the stable and reliable performance of the electronic device. In addition, regular power can also make the backup battery get charged, but check the voltage of the backup battery when it is powered on. If it is too low, replace it immediately to prevent the system data from being lost when the power is turned off.
How to properly maintain NC sliders that are not used for a long time
NC sliding table adopts open-molded aluminum as base body and solid structure to ensure stable and reliable worktable. Taiwan's Shangyin dual guide rails are used with imported screw rods and synchronous belt drives to ensure the speed and accuracy of the sliding table during operation. The correct operation and use can prevent the abnormal wear of the machine tool and avoid sudden failures. With routine maintenance, the equipment can maintain a good technical state, delay the deterioration process, and discover and eliminate hidden troubles in time, thereby ensuring safe operation.