Silo
We offer hot-galvanized Steel Silo ,our silo is assembled type with high strength bolt.The silo wall plate is corrugated type, which is galvanized sheet metal panels, its thickness is generally 0.8 ~ 4.2mm, and wall plates thickness up to 8.4 mm.
According to the silo capacity, we design the bottom asflat bottom and hopper bottom.
*Related Products: Poultry Feed Silo,Cereal Silo,Farm Storage Silo,Feed silo, Conical Silo,Flat Bottom Silo, Storage Silo, Grain Silo .
Silo Grain Silo, Storage Silo, Flat Bottom Silo, Hopper Bottom Silo, Conical Silo, Poultry Feed Silo, Steel Silo Shijiazhuang Goldrain I/E Co.,Ltd. , https://www.goldraingroup.com
For single-stage pump axial force balance generally have the following forms:
1, open a balanced hole
Drill a few holes near the hub of the rear cover of the pump and add a seal on the rear cover. The outer diameter of the seal ring is equal to the outer diameter of the suction inlet of the impeller. Pump work, the back cover ring liquid and suction port connected, the pressure and suction port pressure is similar. Seal outside the cover area and the suction port outside the front cover of the same area, thus sending the liquid pressure in the front and rear cover of the total force is basically equal to a small part of the unbalanced axial force by the bearing. Under normal circumstances, a balanced hole balancing axial force better. Its characteristics are: more leakage, through the balanced hole of the liquid and impede the normal flow of impeller liquid inlet, the centrifugal pump to reduce the efficiency of about 2-5%, only for small single-stage centrifugal pump.
2, using balanced pipe
This method is the same as the method of opening the balance hole, and a mouth ring is arranged on the rear cover of the impeller corresponding to the suction inlet, the liquid in the sealed space is introduced into the pump inlet by a balance tube, Balance, so that the axial force balance, this device requires cross-flow pipe cross-sectional area should be equal to or greater than the mouth ring gap flow area of ​​4-5 times.
3, the use of balanced leaves
In the back of the impeller rear cover symmetrically placed a few radial ribs, when the impeller rotation, the same as the pump blade blade back to the liquid to accelerate the rotation, the centrifugal force increases, so that the pressure on the back of the blade significantly reduced, so that the impeller Both sides of the pressure to achieve balance, the balance depends on the degree of balance of the blade size and the gap between the blade and the pump body. The disadvantage is the pump efficiency is reduced.
4, using double suction impeller
In the flow of single-stage centrifugal pump or a few multistage centrifugal pump with double inlet impeller, the thrust is balanced by its own working conditions, but in fact it is difficult for manufacturers to do the pump two Since the geometry of the side-flow components is exactly the same, there is still a small axial force acting on the rotor, so that it is borne by a single-row radial ball bearing on one end of the shaft.
In addition, for multi-stage pump axial balance device, impeller symmetrical layout method, balanced hub balance axial force and balancing disk balance axial force and other forms.
Pump axial thrust how to balance?
Balance hole can not be too much open, mainly affecting the efficiency of the pump, the following describes some of the axial thrust of the pump balance.