If the owner finds a water leak in the tank, he can go to the repair shop to check it and replace it with a new one. If the leaking situation still exists, the owner should consider: 1. Check that the tank lid is fastened. 2. Test the gas into the tank to see where the tank water is seeping when it is pressurized, and then decide on a remediation plan. 3. Unscrew the lid of the engine plus oil to see if there is any trace of inorganic oil emulsification (punch or corrosion phenomenon). If so, disassemble the engine and replace the cylinder head gasket. 4. There is a problem with the quality of the water tank. If the car is in the process of driving, due to vehicle vibration or vehicle accidents, if the tank water pipe ruptures and leaks, measures can be taken according to specific conditions: When the water leakage does not exceed 1mm crack or 2mm hole, add a bottle of water tank blocking agent to the tank to start the car. 5~10 minutes after the cooling water is turned on, the cooling system will be leaking at the leaking water (or antifreeze) regardless of whether it is a water tank or a rubber pipe and all mats. The leak will not be released after the leak is stopped, and the heat dissipation will not be affected. Blockage occurs. If there is no anti-leakage agent to carry, the individual heat pipe leaks lightly, and the loose tobacco can be temporarily put into the water tank to make use of the circulating pressure of the water to make the tobacco block plug in the leaking part of the heat pipe and temporarily use it. For water tank cooling pipe leakage is more serious, you can cut the leaky heat pipe from the leak, with a soap coated cotton mass cut off the heat pipe, and then use the pliers to cut flat heat pipe head flattened and then crimped Press tight to stop leaking. If the rubber pipe joint is leaking, use a screwdriver to wrap the rubber pipe joint clamp in the rubber pipe joint and then tighten it with pliers. If the rubber tube is damaged, use a tape to wrap it tightly and temporarily use it.
It is mainly used for cooling the hot pellets come out of Pellet Mill. The high temperature 70°C-90°C pellet after cooling is less than 3°C-5°C ambient temperature, and reduce to safe moisture content. The cooling pellets not only increase the pellets hardness but also prevent mildew, eaay for storage and transportation.
The counter flow cooling principle is adopted to cool the pellets with high temperature and high moisture. Hot air touches hot pellets and cool air touches cool pellets so as to avoid the pellet surface crack by shock cooling produced by direct contact between cool air and hot pellets. At the same time, the airclosed airclock is adopted for feeding and bigger air inlet area, therefore it can get better cooling effects.
Cooling Equipment,Granular Material Feed Cooling,Feed Cooling Equipment,Feed Pellet Cooler XinxiangHexie Feed Machienry Manufacturing Co.Ltd , http://www.hxfeedmill.com