Winter car maintenance ten music

Winter car maintenance ten music

As the weather gets colder, the maintenance of the car is becoming more and more important. The following car maintenance ten chapters will help you to safely drive your car for the winter.

A song: wiper If you find that the wiper sticks to the windshield due to low temperature, we can turn the air conditioner on to the hot air. The wind blow mode is the front windshield, waiting for the wiper to open naturally. Note: Do not flush directly with hot water, because it is easy to cause window cracks and deformation of the wiper due to temperature changes.

Two-part song: The cooling system should regularly check whether the water tank, water pump and belt, water pipe, replenishment tank and other components are working properly. If there is any damage or malfunction, it is best to repair or replace it in time. Otherwise, a bucket of antifreeze may be wasted for a small water pipe.

Trilogy: The warm wind is idle for a summer's warm wind, and it often fails. It is best to check if it is normal. Sometimes the antifreeze in the warm water pipe congeals and clogs the circulation pipe. Although it does not affect the traffic, it is very troublesome to repair.

Fourfold: Antifreeze Add or replace in time. Antifreeze may seem like a trivial matter, but it has a great impact on the car. Lightly it blocks the pipeline and when it is heavy, it damages the cylinder. Therefore, careful selection of antifreeze with caution, first, do not mix, and second, do not use fake and shoddy products. In addition, in general, antifreeze should be changed every two years, and it is best to flush the cooling system with clean water before replacing.

Five-part song: The oil inspection mark is low temperature, missing or deteriorating. If the engine oil is too thick in winter, it will affect the start-up and increase the wear of the parts. At the same time, hot engine oil is too thin to reduce lubrication and sealing performance. Use high quality compound oil suitable for winter. If you arrive at or near the prescribed oil change time, it is best to replace it before the weather gets colder.

Sixfold: The windshield glass is the basic condition for safe driving. Therefore, you should periodically scrub the wiper to ensure that the windshield is wiped off in the snow. If conditions permit, you can change the antifreeze windshield to avoid freezing in winter. In addition, add some windshield deicing agent to the glass water. When the windshield freezes, the glass of water is sprayed and the ice melts.

Seven-part song: It is best to add a protective film to the body of the car before winter. Teflon polymer-coated coatings or mirror glazes are resistant to acid rain, snow, and salt water. After the snow, the road was salted and the salt water splashed on the vehicle body was very harmful to the car paint. It was prepared in advance and was not afraid to damage the paint when it was in the snow.

The octave: Chassis chassis always deal directly with rain and snow and it is easy to rust. Speeding tires throw snow with high salinity onto the chassis of the car. After a sunny day, the chassis of the car began to rust. Therefore, it is necessary to give the chassis a rust preventive care.

Nine chapters: Battery batteries are most afraid of low temperatures. Under low temperature environment, the battery capacity is much lower than that at normal temperature. Therefore, in the winter, adequate battery electrolyte should be prepared and the specific gravity of the electrolyte should be adjusted. At the same time clean the battery terminals, and coated with special grease to protect, ensure reliable start-up, extend battery life. If the vehicle is not used for a long time, the battery should be removed and stored in a warm room to prevent the battery from being damaged by ice formation.

Tens: Tire Tire rubber will become hard and relatively brittle in the winter, and the coefficient of friction will decrease, so the tire pressure may not be too high, but it must not be too low. Low outside temperatures and low tire pressure will accelerate tire aging.

Welded Butterfly Valve is a kind of non-sealed butterfly valve. It is widely used in pipelines with medium temperature ≤300°C nominal pressure of 0.1Mpa in building materials, metallurgy, mining, power, etc. to connect, open and close or adjust the amount of medium.

Welded butterfly valve adopts precise J-shaped elastic sealing ring and triple eccentric multi-level metal hard sealing structure, which is widely used in metallurgy, power, petrochemical, and water supply and drainage and municipal construction and other industrial pipelines with medium temperature ≤ 425°C. Adjust flow and cut off fluid usage. Welding butterfly valve is divided into cast steel welding butterfly valve, stainless steel welding butterfly valve, chromium molybdenum steel welding butterfly valve, welding butterfly valve adopts three eccentric structure, valve seat and disc plate sealing surface are made of different hardness and stainless steel, with good corrosion resistance, service life Long, this valve can have two-way sealing function, the product meets the national GB/T13927-92 valve pressure test standard.



Weld Type Butterfly Valve

Weld Type Butterfly Valve,Weld Powder Butterfly Valve,Weld Pneumatic Butterfly Valve,Weld Stainless Steel Butterfly Valve

Henan Yunyu Mechanical Equipment Co., Ltd. , http://www.yunyuvalve.com